understanding BGP MED

Moderator: mike

Post Reply
taborn
Posts: 4
Joined: Mon Nov 27, 2017 6:03 am

understanding BGP MED

Post by taborn » Wed Dec 20, 2017 6:19 am

I have the following topology below
At present, to get to xr4's loopback addresses (10.4.0.0 and 10.5.0.0), all traffic goes through xr2.

Configure xr4 in such a way that a MED of 200 for 10.5.0.0 is sent to xrv2 from xr4 and a MED of 200 for 10.4.0.0 is sent to xrv3.
Traffic for 10.4.0.0 should be going through xrv2 (from xrv1) and traffic to 10.5.0.0 should be going through xrv3

NOTE: only configs related to MED (including RPL's) is required. IP addresses and neighbourships have already been setup

Edited by UD

bgp-med-lab.zip
You do not have the required permissions to view the files attached to this post.

andreysamign
Posts: 23
Joined: Fri May 18, 2018 8:57 pm
Location: Россия
Contact:

understanding BGP MED

Post by andreysamign » Mon May 28, 2018 2:29 am

Hi dear How filter prefixes For out and in in bgp session cisco??

sounknownyet
Posts: 11
Joined: Tue Mar 05, 2019 4:42 pm

Re: understanding BGP MED

Post by sounknownyet » Thu Mar 07, 2019 11:25 am

Hi andreysamign,

this is CCIE section and BGP filtering is contained in CCNP. Route.

Take a look at the chapter:
https://learning.oreilly.com/library/vi ... /ch06.html
-> Create an account with 10 minute email and you''re all set to go.

Then read the chapter and you''ll understand more.

I hope it helps.

Post Reply