Page 2 of 2
Cisco OSPF Area Types Lab CCNP CCIE
Posted: Mon May 28, 2018 10:24 am
by andreysamign
I believe there is a lab sim included with the Cisco Press CCNA library too - I think its a cut down version of the Boson simulator
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Posted: Tue May 28, 2019 9:01 pm
by CiscoJunkie
Hi, what images were used with this lab please?
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Posted: Wed May 29, 2019 6:49 am
by Uldis (UD)
CiscoJunkie wrote: ↑Tue May 28, 2019 9:01 pm
Hi, what images were used with this lab please?
IOL L3 as router and IOL L2 as switch
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Posted: Wed May 29, 2019 6:55 am
by CiscoJunkie
When I try turning nodes on with this specific lab, they all shut down immediately.
Startup config was enabled prior.
I can add IOL L2/3 in on separate project and they start fine.
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Posted: Wed May 29, 2019 2:05 pm
by Uldis (UD)
Wipe node before start !!!
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Posted: Wed May 29, 2019 7:00 pm
by CiscoJunkie
Uldis (UD) wrote: ↑Wed May 29, 2019 2:05 pm
Wipe node before start !!!
Yep, did that as well and nodes still stop after starting.
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Posted: Tue Dec 03, 2019 10:27 am
by sounknownyet
Guys, I might have a silly question but when you run the routers with the startup-config will you get the show result as shown in the lab next to routers? Because I do not unfortunately.