Hi,
I am new at Eve-Ng and using community version. I am trying ti build LAB with cisco ROuter and Switches.
I was able to do it. But once I start a Switch/Router and logged in via telnet on it I can't see the full configuration
on that Router/Switch. Also can't see the full interface list. Lets Say I am cionfiguring Interface Gig 5/1 with an IP
address and I can't see the configuration after using command " Show Running Config". Am I doing anything wrong?? Please help.
Cisco Switch/Router Running Configuration
Moderator: mike
-
- Posts: 3
- Joined: Wed May 24, 2017 12:39 pm
Re: Cisco Switch/Router Running Configuration
Hi,
This is problem with windows native telent client. Use Putty or SecureCRT instead.
This is problem with windows native telent client. Use Putty or SecureCRT instead.