csr1000v fuji

[lvalero]

Hello,

I tried to apply the procedure :
http://www.eve-ng.net/documentation/how ... li-routers

for denali and everest to a fuji image :

csr1000v-universalk9.16.07.02.iso

everything is ok except that the router has no gig interfaces :
Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
Router#

Regards.

[Uldis (UD)]

Same answer be sure yu have updated/upgraded EVE community vers 92 !!!
http://www.eve-ng.net/community

works like charm mate
dot1q as well, and interfaces as well, other end simple IOL switch with trunk, SVI10 all works

Code: Select all

Router#sh ip int brief
Interface              IP-Address      OK? Method Status                Protocol
GigabitEthernet1       unassigned      YES unset  up                    up      
GigabitEthernet1.10    192.168.10.2    YES manual up                    up      
GigabitEthernet2       unassigned      YES unset  administratively down down    
GigabitEthernet3       unassigned      YES unset  administratively down down    
GigabitEthernet4       unassigned      YES unset  administratively down down    
Router#sh ver
Cisco IOS XE Software, Version 16.08.01a
Cisco IOS Software [Fuji], Virtual XE Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.8.1a, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2018 by Cisco Systems, Inc.
Compiled Tue 03-Apr-18 18:43 by mcpre

interface GigabitEthernet1
 no ip address
 negotiation auto
 cdp enable
 no mop enabled
 no mop sysid
!
interface GigabitEthernet1.10
 encapsulation dot1Q 10
 ip address 192.168.10.2 255.255.255.0

[lvalero]

Hello,

After upgrading i still have the same issue :

Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
Router#

Router#sh ver | i Version
Cisco IOS XE Software, Version 16.08.01
Cisco IOS Software [Fuji], Virtual XE Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.8.1, RELEASE SOFTWARE (fc3)

Regards

[lvalero]

vmxnet3 + v92 solved the issue.

Regards