Hi,
I am new to eve-ng and I tried with iol layer 3 image. It is simple setup test with 2 routers connect to each eth0/0 with single subnet ip address assigned. When I shutdown R1 eth0/0 interface, R2 eth0/0 is still up and does not aware that R1 interface is down even though it is directly connected. I just want to know whether this is normal with eve-ng and iol or does it need to make any additional setting so that routers will aware of connection link is down?
Below is my test setup. I am using eve-ng community edition.
10.1.1.1/24 10.1.1.2/24
[R1]-eth0/0 <--------------------------->eth0/0-[R2]
I can ping between R1 and R2.
iol and interface status
Moderator: mike
-
- Posts: 5084
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: iol and interface status
it particular cisco image issue, not EVE
Layer 1 is not supported on virtual image.
Means operational up or down
Layer 1 is not supported on virtual image.
Means operational up or down
-
- Posts: 3
- Joined: Tue Sep 04, 2018 9:06 pm
Re: iol and interface status
I tried 2 version of iol i86bi-linux-l3-adventerprisek9-15.5.2T.bin and i86bi-linux-l3-adventerprisek9-15.4.2T.bin and both are showing same issue. Is there any particular image version that support layer 1 up and down? Are you saying layer 1 up down does not support with iol?
-
- Posts: 5084
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: iol and interface status
IOL and no one of virtual images has such layer 1...
they Simply has not operational status function...
IOL, vIOS whatever...
they Simply has not operational status function...
IOL, vIOS whatever...