Hi Guys,
May I ask a question regarding the NXOS. I followed the steps on how to install eve-ng and how I may upload the IOS.
However when I start the node. it is usually gray and when you hit start it will change to blue. But still no reaction from the device.
Device not able to boot
Moderator: mike
-
- Posts: 1
- Joined: Mon Mar 25, 2019 1:10 pm
Device not able to boot
You do not have the required permissions to view the files attached to this post.
-
- Posts: 5081
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: Device not able to boot
1. Your EVE must have enabled Intel VT-X/EPT fuction on the CPU. Check EVE cookbook install steps for it.
2. make sure if image is prepared correctly
https://www.eve-ng.net/index.php/docume ... 0v-switch/
Uldis
2. make sure if image is prepared correctly
https://www.eve-ng.net/index.php/docume ... 0v-switch/
Uldis
-
- Posts: 5
- Joined: Thu Nov 30, 2017 10:40 am
Re: Device not able to boot
Are you booting an UEFI version of Nxos ? 9.x ?
Check your /opt/unetlab/data/Logs/unl_wrapper.txt file after starting the node or tail -f it as starting the node.
Look for the bios option the template is attempting to use.
such as
-bios /opt/qemu/share/qemu/OVMF-sata.fd
Now check for the existence of that bios file.
If that file does not exist you will get the observed behavior. Turns blue followed closely by grey out.
Check your /opt/unetlab/data/Logs/unl_wrapper.txt file after starting the node or tail -f it as starting the node.
Look for the bios option the template is attempting to use.
such as
-bios /opt/qemu/share/qemu/OVMF-sata.fd
Now check for the existence of that bios file.
If that file does not exist you will get the observed behavior. Turns blue followed closely by grey out.
-
- Posts: 5081
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: Device not able to boot
it is wrong advice.
you must strictly follow how to and use ready cisco qcow2 image, rnaming it to sataa.qcow2
Thats it.
No any extra qemu options need to add .
Uldis
you must strictly follow how to and use ready cisco qcow2 image, rnaming it to sataa.qcow2
Thats it.
No any extra qemu options need to add .
Uldis