Hello Boss,
As there is one requirement for using sub-interface running TLOC Extension.
ping doesn't work in sub-interface
Can you give me same advice ?
Thanks a lot
version:18.3.3
vEdge1:
0 ge0/7 ipv4 - Up Up NA -
0 ge0/7.10 ipv4 10.193.197.244/31 Up Up NA -
vedge1# ping 10.193.197.245 (ping p2p fail)
Ping in VPN 0
PING 10.193.197.245 (10.193.197.245) 56(84) bytes of data.
From 10.193.197.244 icmp_seq=1 Destination Host Unreachable
From 10.193.197.244 icmp_seq=2 Destination Host Unreachable
vedge1# ping 10.193.197.244 (ping itself , it is ok)
Ping in VPN 0
PING 10.193.197.244 (10.193.197.244) 56(84) bytes of data.
64 bytes from 10.193.197.244: icmp_seq=1 ttl=64 time=0.018 ms
64 bytes from 10.193.197.244: icmp_seq=2 ttl=64 time=0.048 ms
vedge2# show interface descriptio
0 ge0/7 ipv4 - Up Up NA -
0 ge0/7.10 ipv4 10.193.197.245/31 Up Up NA -
Viptel sub-interface ping doesnt work. So TLOC Extension doesn't work
Moderator: mike
-
- Posts: 37
- Joined: Mon May 22, 2017 8:27 am
-
- Posts: 5067
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: Viptel sub-interface ping doesnt work. So TLOC Extension doesn't work
Make sure if you have set e1000 interface for vEdgeEdit node and change nic type to e1000
All is working
All is working
-
- Posts: 37
- Joined: Mon May 22, 2017 8:27 am
Re: Viptel sub-interface ping doesnt work. So TLOC Extension doesn't work
Thank you UD boss.
I will try it tomorrow morning.
I will try it tomorrow morning.