DHCP and NAT Version 1

Any copyright material exchange is strictly forbidden. Any member violate this rule will be banned without warning.

Moderator: mike

Post Reply
kansukre
Posts: 3
Joined: Tue Mar 21, 2017 4:00 pm

DHCP and NAT Version 1

Post by kansukre » Thu Jan 24, 2019 8:25 pm

ImageLab Scenario:

In this lab, you will be configuring routers and a DHCP server to enable DHCP IP address assignment and Network Address Translation (NAT) using EVE-NG. The network diagram of Figure 1 illustrates a LAN network connected to a WAN. In this network, a WAN DHCP server provides the dynamic IP address assignment to the LAN hosts (Hosts 1,2 and 3). To enable DHCP IP address assignment in this network, Router R1 must be configured as a DHCP relay agent. As discussed in lecture, a DHCP relay agent forwards DHCP packets between clients and servers when they are not on the same physical subnet. Relay agent forwarding is distinct from the normal forwarding of an IP router, where IP datagrams are switched between networks somewhat transparently. By contrast, relay agents receive DHCP messages and then generate a new DHCP message to send out on another interface. The relay agent sets the gateway address (giaddr field of the DHCP packet) and, if configured, adds the relay agent information option.

In addition, this lab will demonstrate how NAT translates IP addresses. As discussed in lecture, NAT translates non-routable private, internal addresses into routable, public addresses. NAT has an added benefit of providing a degree of privacy and security to a network because it hides internal IP addresses from outside networks. In this Lab, you will configure dynamic and static NAT. To demonstrate this capability, Router R1 will be configured to perform NAT translation.
You do not have the required permissions to view the files attached to this post.
Last edited by kansukre on Fri Jan 25, 2019 2:56 pm, edited 1 time in total.

Uldis (UD)
Posts: 2511
Joined: Wed Mar 15, 2017 4:44 pm
Location: London
Contact:

Re: DHCP and NAT Version 1

Post by Uldis (UD) » Thu Jan 24, 2019 8:57 pm

Please add screenshot of your lab
Uldis

Post Reply