Page 1 of 1

VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Sat Sep 02, 2017 10:57 pm
by Uldis (UD)
Hi,
I had a chance today test promised VXLAN features on just announced Cisco 7.0.3.I7.1 NX9K image.
Used for Lab:
7.0.3.I7.1. qcow2 image from Cisco, but each node need x4 CPU and 8G RAM
vIOS L2 Switches vers 15.2, can be used IOL I believe
IOL L3 routers 15.4.2T
VPCS simplest PC hosts.
Dont be scared when you will enable features on nexus, like OSPF, PIM, it will yell that no proper licence in it, all works, ignore these messages.

Lab is fully completed, and all final configs saved for nodes. Just load proper images and run.

Lab nexus login: admin/admin

Enjoy!!!
UD

Re: VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Sun Sep 03, 2017 11:39 am
by komalthecoolk
I am using the nxosv-final.7.0.3.I6.1 image and setup a similar network to yours. For some reason I feel like Eve-NG is taking up more resources than the same setup on GNS3 with the same image. Any tips on how I can optimize it?

Re: VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Sun Sep 03, 2017 8:40 pm
by Uldis (UD)
it is depends from your PC, CPU and RAM,
Just did tests on bare intalled EVE and ESXi versions, no one did spike on CPU, after it was booted, CPU dropped like 0-1%.

BUT GNS3 is GNS3, sorry:)


UD

Re: VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Sun Sep 10, 2017 3:27 pm
by Dreamer
great share !

Re: VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Wed Oct 25, 2017 3:59 pm
by zipporo
Thanks!!!!!

Re: VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Fri Nov 24, 2017 8:54 am
by weeping
Many Thanks!!
That's one of the labs that I want to use EVE to do.

Re: VXLAN NXOS 7.0.3.I7.1 LAB by UD

Posted: Tue Oct 16, 2018 7:12 am
by sanjeevlsg
Thank you for LAB ,do you happen to have some show commands I did couple of them for VXLAN but couldn't get all output as expected

VXLAN NXOS 7 0 3 I7 1 LAB by UD

Posted: Sat May 25, 2019 1:03 am
by Priestmot
Hello Waisudin

I have most of the lab figured out but having issues with BGP connection over the Multihops.
Can you share the BGP part of the configs on PE1 and PE2?

thanks