SDWAN vlan interface

Moderator: mike

Post Reply
naray84
Posts: 5
Joined: Mon May 22, 2017 8:24 am

SDWAN vlan interface

Post by naray84 » Thu Sep 19, 2019 6:25 am

hi,


when i configure interface on viptela vedge18.4.3 and assign ip to interface, i am able to ping IP assigned to devices in same network. but when i assign gex.x interface to vpn 0 and then assign gex.x/100 interface to vpn 100 interface , then i am not able to ping devices in the same subnet. i also change config of switch connected to viptela as trunk port and all vlans are allowed.

Uldis (UD)
Posts: 2578
Joined: Wed Mar 15, 2017 4:44 pm
Location: London
Contact:

Re: SDWAN vlan interface

Post by Uldis (UD) » Thu Sep 19, 2019 9:38 am

Your config is wrong then.
I just tested 18.4.3 vEdge all works
You do not have the required permissions to view the files attached to this post.

naray84
Posts: 5
Joined: Mon May 22, 2017 8:24 am

Re: SDWAN vlan interface

Post by naray84 » Fri Sep 20, 2019 12:16 am

Thanks for the reply.
not sure. i did the same

04.PNG
01.PNG
05.png
You do not have the required permissions to view the files attached to this post.

Post Reply