Page 1 of 1

understanding BGP MED

Posted: Wed Dec 20, 2017 6:19 am
by taborn
I have the following topology below
At present, to get to xr4's loopback addresses ( and, all traffic goes through xr2.

Configure xr4 in such a way that a MED of 200 for is sent to xrv2 from xr4 and a MED of 200 for is sent to xrv3.
Traffic for should be going through xrv2 (from xrv1) and traffic to should be going through xrv3

NOTE: only configs related to MED (including RPL's) is required. IP addresses and neighbourships have already been setup

Edited by UD

understanding BGP MED

Posted: Mon May 28, 2018 2:29 am
by andreysamign
Hi dear How filter prefixes For out and in in bgp session cisco??

Re: understanding BGP MED

Posted: Thu Mar 07, 2019 11:25 am
by sounknownyet
Hi andreysamign,

this is CCIE section and BGP filtering is contained in CCNP. Route.

Take a look at the chapter: ... /ch06.html
-> Create an account with 10 minute email and you''re all set to go.

Then read the chapter and you''ll understand more.

I hope it helps.