CTS command on Cisco switch

[Uzair]

Hello - I am new to this community and would like to seek your support.

I am using Eve for preparing CCIE-security. I am using a L2 switch but it seems there's no support for CTS commands. Do you know which switch I would need to add to have this feature available? I looked up cisco.com and noticed this command was introduced on 6500 series switch.

Any advice is highly appreciated.

Thank you.

[Uldis (UD)]

Only one version of cisco vIOS L2 from may 2018, obtained from VIRL supported CTS...
REst no..
Uldis

[Uzair]

Thanks Uldis.

The one I am using is from 2016. Alright. Thanks again (y).

BR,
-Uzair

[Uzair]

One more question.

Does Eve support ASA-X? It seem only ASA-X supports clustering with port-channels correct?

I was looking into your topology you posted for CCIE security v5. You are using ASA-X. I have the .bin file for ASA-X which I copied in /opt/unetlab/addons/iol/bin folder. When I boot up the ASA, it turns up but then shuts down. L2 and L3 .bin files successfully boots up but others like ASA (asa971-smp-k8.bin and asa944-2-smp-k8.bin) and switch iOS like c6848x-ipservicesk9-mz.SPA.155-1.SY1.bin and nexus .bin files boots but then shutdown right after booting up.

Please help.

Thank you.

[Uldis (UD)]

yes
one unformal ASA exist as virtual image which supports CTS and cluster...
It is same old ASA 9.1.5, but smart guys applied real serial nr on it and loaded cluster lic..
So in viertual such asa exist but not supported by cisco....

[Uzair]

Alright. But why does the devices boot then shutdown when I copy .bin images under /opt/...../iol/bin folder?

Thanks,
-Uzair

[Uldis (UD)]

Supported bin images are mentioned here.
Any other binaries will not work
http://www.eve-ng.net/documentation/supported-images
Uldis