Support and News Forum

Finally worked my way through the ROUTE OCG, and here are 95% of the labs for EVE/UNL, and probably 95% accurate...
As all we get in the OCG is the topology, some config fragments and some show command output, I've reverse engineered what I can and made some assumptions for the rest...and done some tidy up...Enjoy!
Edit: added some missing Labs from chapter 4

Thank you so much for this!!! Perfect for my studies!!!

Thanks a lot, just a quick question since I'm not used yet to eve-ng/unetlab , used to run everything in cli with IOU on an Ubuntu install.

Is it correct there are no startup-configs in the routers ?

All the configs should have been exported and ready to run. If any issues, let me know which lab(s).

Well, all the labs so it looks as an issue on my end ,could it be that I lose the startup-configs because either I'm using a higher eve-ng version
EVE-NG version: 2.0.3-60 or a different IOL than you when you created the lab ?

I just do import , select the ZIP file , then start one of the labs .

Thank you, Sir!
Can you confirm that all devices in labs (switches and routers) use the same L3 IOL image?

Lastic wrote: ↑

Sun May 07, 2017 1:03 pm

Well, all the labs so it looks as an issue on my end ,could it be that I lose the startup-configs because either I'm using a higher eve-ng version
EVE-NG version: 2.0.3-60 or a different IOL than you when you created the lab ?
I just do import , select the ZIP file , then start one of the labs .

Did an export all from EVEv60 at home, and imported all to UNLv14 at work (cleared all my tmp folder as well)...have done a random sample test, all mine boot from the exported config

kofeee wrote: ↑

Sun May 07, 2017 10:17 pm

Can you confirm that all devices in labs (switches and routers) use the same L3 IOL image?

Using IOL versions:
L3-adventerprisek9-m-15.4-2T4.bin (for most Labs)
L3-adventerprisek9-m-12.4.bin (for the BGP labs)
L2-adventerprisek9-m-15.2-20150703.bin (can't recall if there are any L2 switches in there, but if there are...)

But if you load the lab, and click "nodes" it will list the IOL versions used

azaghul33 wrote: ↑

Mon May 08, 2017 12:55 am

kofeee wrote: ↑

Sun May 07, 2017 10:17 pm

Can you confirm that all devices in labs (switches and routers) use the same L3 IOL image?

Using IOL versions:
L3-adventerprisek9-m-15.4-2T4.bin (for most Labs)
L3-adventerprisek9-m-12.4.bin (for the BGP labs)
L2-adventerprisek9-m-15.2-20150703.bin (can't recall if there are any L2 switches in there, but if there are...)

But if you load the lab, and click "nodes" it will list the IOL versions used

Got it. Huge thank you again!

Thank you for sharing the Lab.