Cisco OSPF Area Types Lab - CCNP | CCIE
Moderator: mike
-
andreysamign
- Posts: 23
- Joined: Fri May 18, 2018 8:57 pm
- Location: Россия
- Contact:
Cisco OSPF Area Types Lab CCNP CCIE
I believe there is a lab sim included with the Cisco Press CCNA library too - I think its a cut down version of the Boson simulator
-
CiscoJunkie
- Posts: 6
- Joined: Tue May 28, 2019 8:08 pm
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Hi, what images were used with this lab please?
-
Uldis (UD)
- Posts: 5148
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
IOL L3 as router and IOL L2 as switch
-
CiscoJunkie
- Posts: 6
- Joined: Tue May 28, 2019 8:08 pm
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
When I try turning nodes on with this specific lab, they all shut down immediately.
Startup config was enabled prior.
I can add IOL L2/3 in on separate project and they start fine.
Startup config was enabled prior.
I can add IOL L2/3 in on separate project and they start fine.
-
Uldis (UD)
- Posts: 5148
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Wipe node before start !!!
-
CiscoJunkie
- Posts: 6
- Joined: Tue May 28, 2019 8:08 pm
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Yep, did that as well and nodes still stop after starting.
-
sounknownyet
- Posts: 18
- Joined: Tue Mar 05, 2019 4:42 pm
Re: Cisco OSPF Area Types Lab - CCNP | CCIE
Guys, I might have a silly question but when you run the routers with the startup-config will you get the show result as shown in the lab next to routers? Because I do not unfortunately.