Support and News Forum

Hi,

I'm using the Community version and would like to know if the Cisco Nexus 9000v switch supports Virtual Port Channels (vPC) This is because whenever I try to configure it, the switch CLI doesn't recognize vPC commands. I have tried two images: nxosv9k-7.0.3.17.7 and nxosv9k-9.2.1. In both cases configuration of vPC is not possible. Other than that, the switch works fine.

Thank you.

Hi,

cli is present in v9.3.3 (don't forget to configure "feature vpc" tough)
Rich

It was the feature vpc command what was missing Duh!

Thanks Rich!