Hello all,
I have a question about the Juniper vQFX. I made a script that pulls our infrastructure from librenms and converts it to eve-ng template.
But I seem to have run into an issue that I can only have 10/12 ports. If you do ifconfig on qfx-FE it only goes upto eth9. If you do ifconfig -a there are 52.
Ps. I did have to fix some stuff in eve-ng to connect this many ports to qemu. By adding a pci-bus but even ports on the primary bus are not detected.
Juniper vQFX 12 port limitation
Moderator: mike
-
- Posts: 5
- Joined: Tue Jun 08, 2021 8:15 am
Re: Juniper vQFX 12 port limitation
Anyone have suggestions or is this just the way it is?
-
- Posts: 5
- Joined: Tue Jun 08, 2021 8:15 am
Re: Juniper vQFX 12 port limitation
https://github.com/Juniper/vqfx10k-vagrant
Seems to state rather clearly there is a 12 port limitation. (If only I read this before).
But hope remains I have been put in contact with someone who is supposedly running more than 12 ports on there vqfx.
Seems to state rather clearly there is a 12 port limitation. (If only I read this before).
But hope remains I have been put in contact with someone who is supposedly running more than 12 ports on there vqfx.