ASAv does not boot up properly
Posted: Wed Mar 21, 2018 6:50 pm
Hello there!
So, I have installed and configured ASA (asa-915-k8), it working like a charm. Then, I tried to install ASAv (asav-941-200), but unfortunately without success.
The ASAv node does not boot up properly after clicking on it. I have followed this documentation, step by step:
http://www.eve-ng.net/index.php/documen ... cisco-asav
Directory created:
Image inside the directory and its permissions:
Inside the image directory: /opt/unetlab/addons/qemu/asav-941-200
apt-get update
apt-get install libguestfs-tools
cd /opt/unetlab/addons/qemu/asav-941-200/
guestfish -a virtioa.qcow2
run
mount /dev/sda2 /
touch /use_ttyS0
umount /
exit
Then, fixing its permissions:
/opt/unetlab/wrappers/unl_wrapper -a fixpermissions
Evidence:
Unfortunately, even after following the instructions above, it does not boot up properly. It starts and after 2~3 seconds it stops.
Would you guys help me out?
Thanks in advance for reading this through.
So, I have installed and configured ASA (asa-915-k8), it working like a charm. Then, I tried to install ASAv (asav-941-200), but unfortunately without success.
The ASAv node does not boot up properly after clicking on it. I have followed this documentation, step by step:
http://www.eve-ng.net/index.php/documen ... cisco-asav
Directory created:
Image inside the directory and its permissions:
Inside the image directory: /opt/unetlab/addons/qemu/asav-941-200
apt-get update
apt-get install libguestfs-tools
cd /opt/unetlab/addons/qemu/asav-941-200/
guestfish -a virtioa.qcow2
run
mount /dev/sda2 /
touch /use_ttyS0
umount /
exit
Then, fixing its permissions:
/opt/unetlab/wrappers/unl_wrapper -a fixpermissions
Evidence:
Unfortunately, even after following the instructions above, it does not boot up properly. It starts and after 2~3 seconds it stops.
Would you guys help me out?
Thanks in advance for reading this through.