Support and News Forum

Hi can someone give me direction how to import FGT into UNL.

thanks..

it is so much like ASA

create local director on the following path

# mkdir -p /opt/unetlab/addons/qemu/fortinet-5.2.3b670

upload your image to the created director and lets assume its name is fortios_5-2-3.qcow2 ( by WINSCP or FileZilla )
and enter the following commands

# cd /opt/unetlab/addons/qemu/fortinet-5.2.3b670

# mv fortios_5-2-3.qcow2 virtioa.qcow2

# /opt/unetlab/wrappers/unl_wrapper -a fixpermissions

Thanks for your quick response,

Which extension does UNLN support, bcz I can see multiple Platform on Fortinet site...

like *.ovf, *.VMware, *.openxen, *.hyperv,*.kvm

Thanks..

i think it must be a qemu appliance

Once again thanks for your help,

I've another question , sorry being so dump but i'm very new to UNL so I'm asking many question,

I'm able to import FGT so far, but I don't have access to console either via telnet or SSH, would you please guide me ...

Hi I already installed in my laptop ,but question is how can I configure initial config, ihow can I access fortigate firewall,

I've imported FGT into UNL but I don't know how to get access of FGT

Connect management interface to home cloud. Add on topo network Cloud0 and connect mgmnt interface to it.
Then setup IP from your EVE subnet...

Hi I've couple of issue.

1) i'm starting Fortigate firewall but if you see in picture its showing stop
2) how to I configure ip address as I don't have access to console..

image is faulty, thats it