Support and News Forum

Hi all,

I have a problem with L2 Image in EVE, I use image:

i86bi-linux-l3-adventerprisek9-15.3.1.3T
i86bi-linux-l2-adventerprisek9-15.1a

when I started this node and configured it, after few minutes i have this error below.
Exception:
Frame pointer BCB1BC44, PC = 8B09663

LINUX-EXT-SIGNAL: U_SIGSEGV(11), Process = MOP Protocols
-Traceback= 0x8B09663z 0x8BB395Ez 0x8BC2C51z 0x8BC2B5Fz 0x83B879Fz 0x8BC2C82z 0x8BC2B5Fz 0x83B879Fz 0x8BC2C82z 0x8BC2B5Fz 0x83B879Fz 0x8BC2C82z 0x8BC2B5Fz 0x83B879Fz 0x8BC2C82z 0x8BC2B5Fz

EAX = B85578BD EBX = 02000000 ECX = 8CBCB1BC EDX = 02000000
ESP = BCB1BC44 EBP = BCB1BC48 ESI = BDFEA468 EDI = BDFEA468
EFL = 00010286 EIP = 08B09663
CS = 0023 SS = 002B DS = 002B ES = 002B
FS = 0000 GS = 0063
Segmentation fault
12/5 11:9:44.533 INF Tennant_id = 2
12/5

At this point the node goes in power down and if I try to start it the node doesn't work.
Someone of you have the same problem??

Regards

short memory assigned
I recommend for each IOL assign 1024M RAM

Uldis (UD) wrote: ↑

Mon Jun 12, 2017 12:42 pm

short memory assigned
I recommend for each IOL assign 1024M RAM

Hi,

if I use 2048M for RAM have the same problem.

the topology that I use is:

Four Switch in full mesh
i86bi-linux-l2-adventerprisek9-15.1a
2048M ram for all.

Configuration for all:

ena
conf t
spanning-tree mode rapid-pvst (if I use or not this command nothing change)
int range e0/0-3
sh
int range e1/0-3
sh
int range e0/0-1
sw tru enc dot
sw mo tru
sw trun nati vlan 99
channel-g 1 mode active
int range e1/0-1
sw tru enc dot
sw mo tru
sw trun nati vlan 99
channel-g 3 mode active
int range e0/2-3
sw tru enc dot
sw mo tru
sw trun nati vlan 99
channel-g 2 mode active
int po1
sw tru enc dot
sw mo tru
sw trun nati vlan 99
int po 2
sw tru enc dot
sw mo tru
sw trun nati vlan 99
int po 3
sw tru enc dot
sw mo tru
sw trun nati vlan 99

Regards

try other IOL image

Just tried your cfg on IRON L2 image works fine