Cisco FirePower Management Center Install
Moderator: mike
-
- Posts: 6
- Joined: Wed Jul 19, 2017 1:56 am
Cisco FirePower Management Center Install
I attempted to install Cisco Firepower Management Center 6.2.0 on a bare metal setup. The setup is fine and working without issues. The HW was Intel Xeon 18C / 64GB RAM / 500GB SSD with 6x 1GEb ethernet interfaces. When I boot the FMCv I get the following (See screenshot attached) I have followed the instructions carefully and even attempted to build the bare metal setup 3x times. I have also followed the instructions for fixing the permissions given in the FAQ. Please help. If you cannot see the screen capture, the boot goes directly to iPXE boot up and eventually says "no bootdisk"
You do not have the required permissions to view the files attached to this post.
-
- Posts: 533
- Joined: Wed Mar 15, 2017 1:54 pm
Re: Cisco FirePower Management Center Install
image not seen by emulaor...
image naming probably wrong...
E.
image naming probably wrong...
E.
-
- Posts: 6
- Joined: Wed Jul 19, 2017 1:56 am
Re: Cisco FirePower Management Center Install
Ah ha, found the issue. The naming was indeed incorrect and the directions in the tutorial are incorrect! I have it running no issues now.
-
- Posts: 4
- Joined: Fri Jun 16, 2017 6:24 am
Re: Cisco FirePower Management Center Install
Hi,
I see the same behavior in my case. I proceed with this guide http://eve-ng.net/index.php/documentati ... images-set
So, what should be the name of that image? Just hda.qcow (like in above link) or somehow another?
I see the same behavior in my case. I proceed with this guide http://eve-ng.net/index.php/documentati ... images-set
So, what should be the name of that image? Just hda.qcow (like in above link) or somehow another?
-
- Posts: 533
- Joined: Wed Mar 15, 2017 1:54 pm
Re: Cisco FirePower Management Center Install
mv Cisco_Firepower_Management_Center_Virtual-6.2.0-362.qcow2 /opt/unetlab/addons/qemu/firepower6-FMC-6.2.0-362/hda.qcow
sould be
mv Cisco_Firepower_Management_Center_Virtual-6.2.0-362.qcow2 /opt/unetlab/addons/qemu/firepower6-FMC-6.2.0-362/hda.qcow2
E.
PS: Howto is correct now...
sould be
mv Cisco_Firepower_Management_Center_Virtual-6.2.0-362.qcow2 /opt/unetlab/addons/qemu/firepower6-FMC-6.2.0-362/hda.qcow2
E.
PS: Howto is correct now...
-
- Posts: 4
- Joined: Fri Jun 16, 2017 6:24 am
Re: Cisco FirePower Management Center Install
I did.
Also, the folder name for FTD is incorrect. Now it indicates for FMC.
Also, the folder name for FTD is incorrect. Now it indicates for FMC.