static ip disappears after running wizard

[rasputinlv]

Hello guys.
Im having issue with setting up static IP. After completing bare server install static IP works fine.
I get to to setup wizard, go thru it, them after reboot I get message no ip on eth0.
I went to VM version, which was working fine with DHCP, deleted .configured file, after reboot wizard came up, I set static IP and after reboot same issue: no IP on eth0.
Please advice.
Thanks an advance.

[Uldis (UD)]

read carefully points 8 and 9
http://www.eve-ng.net/index.php/documen ... re-install

UD

[rasputinlv]

Thank you very much for reply!
I did those steps and after next reboot everything was fine, but after step 14 eth0 lost configuration.
Thanks again.

[rasputinlv]

I re-run wizard with dhcp settings, then edited interfaces file with static IP, its' working fine that way.
Thanks again for help.

[Uldis (UD)]

second answer from top
http://www.eve-ng.net/index.php/faq

[rasputinlv]

When I delete .congiured file, and run wizard after reboot, it doesnt work.
In interfaces file it' puts static configuration under pnet0 interface, is this how it should be?
Thanks for reply

[Uldis (UD)]

Script works, ofc if you didnt set stat IPs on interface yourself...

[rasputinlv]

still no luck with script/wizard.
It works when I setup static IP during initial server setup, then I install eve, and its actually working if I don't logon to server via cli.
As soon as I logon, wizards starts and messes it up.
Is there way not to run wizard once it's installed?
Thanks for replys

[RTG]

I have the same issue. But mine its a Virtual Machine running on ESXi. (Followed ULDIS How to "OVA on ESXI VIDEO")

Installed on ESXi host and after the wizard, the network configurations just disappears.

When I use the command "ifconfig" the only interface available is the lo0.
On the "/etc/network/interfaces" the ip address is assigned to a "pnet0" interface.

What could be the problem?

Update: Tried with DHCP enabled, and it works. Maybe something on the script is breaking the configuration when you set the ip to static?

[ecze]

Yes, ip goes to pnet0

E.