Hi,
I have problem with start up configs.
I clone lab from my working lab.
When You did that start up configs are empty.
I exported configs in my working lab and copied them to start up configs in cloned lab.
I wiped all routers and set all startup configs to exported cfgs.
After that I run all nodes and get error like below:
What is wrong?
Earler I had no problem with copy configs to new labs...
Running 64 bit architecture
Initializing VMM
Virtual address sharing is disabled
emGetLink: unit 0 is not VALID
Time from clock is FRI NOV 10 11:19:45 2017 UTC
Initial DNS resolving preference is ipv4-only
SMP: 2 cores available
Attempting to exec primary configuration file:
'cf1:\config.cfg' ...
MAJOR: CLI #1009 An error occurred while processing a CLI command -
File cf1:\config.cfg, Line 9: Command "configure" failed.
CRITICAL: CLI #1002 The system configuration is missing or incomplete because an error occurred while processing the configuration file.
MAJOR: CLI #1008 The SNMP daemon is disabled. To enable SNMP, execute the command 'config>system>snmp no shutdown'.
TiMOS-B-15.0.R1 both/x86_64 Nokia 7750 SR Copyright (c) 2000-2017 Nokia.
All rights reserved. All use subject to applicable license agreements.
Built on Tue Mar 7 09:53:27 PST 2017 by builder in /builds/rel15.0/150B/R1/panos/main
Login: admin disconnect
Password:
Login:
Problem with start up configs
Moderator: mike