Support and News Forum

Hello Experts,

I am trying to build a LAB that VCP will inter-connected with two vFPCs, I just referred to below link:
https://jncie.eu/how-to-deploy-vmx-with ... ve-ng-kvm/

I can see two vFPC in command of "show chassis fpc" result, and I can also see ge-1/x/x, ge-2/x/x in command output "show interface terse".

and I trying to configure IP address on both side of a link, however it's failed to ping remote IP, and no ARP data, and no ospf neighbor.

I am not sure what the problem is, need your experience here, or a correct way to build two or more FPCs to one VCP.

thanks for your suggestion, any information is appreciated!

Stanley

My good friend Christian did it
https://jncie.eu/how-to-deploy-vmx-with ... ve-ng-kvm/

Yes, I was refer to this post from your friend too, but it's not working as expected.

The result is ping failed, and IGP does not work, I cannot see any OSPF neighbor on the interface.

so I am wondering there is something goes wrong, but not sure why... if any further information, please give me some hint.

thanks for your help.

Stanley

follow next webcast https://learningportal.juniper.net/juni ... x?id=11421

Christian will be able to answer and to show you how to do it...

E.

Hello, just registered, thanks for your information!

Stanley

can you post the output of show chassis fpc