Issue with eve-ng
Posted: Fri May 03, 2024 11:39 pm
Hello,
I tried to get a lab of Cisco Cat8000v working on EVE. The EVE VM is on KVM, specifically on an UNRAID server.
EVE works fine (although its a Beta POS from 1995, IMO). I followed the 8000v install on the Eve website. When I put a few 8000v together and throw on some basic configs they get really wonky. For example, if I were to 'show run' in the 8000v it would take a long time to show the output. Another time I did a 'write mem' and the entire 8000v crashed. Additionally, the actual configs wont persist after I stop the node even though I extract the configs & set startup config in Eve prior to stopping the node. I am running crypto in the 8000v bc I'm labbing up some BASIC vpn stuff.
I tried doubling the Cat8000v CPUs to 4 and memory to 8GB. It does boot faster but the wonky stuff remains.
Does EVE just suck, is it the 8000v, or is it me?
I tried to get a lab of Cisco Cat8000v working on EVE. The EVE VM is on KVM, specifically on an UNRAID server.
EVE works fine (although its a Beta POS from 1995, IMO). I followed the 8000v install on the Eve website. When I put a few 8000v together and throw on some basic configs they get really wonky. For example, if I were to 'show run' in the 8000v it would take a long time to show the output. Another time I did a 'write mem' and the entire 8000v crashed. Additionally, the actual configs wont persist after I stop the node even though I extract the configs & set startup config in Eve prior to stopping the node. I am running crypto in the 8000v bc I'm labbing up some BASIC vpn stuff.
I tried doubling the Cat8000v CPUs to 4 and memory to 8GB. It does boot faster but the wonky stuff remains.
Does EVE just suck, is it the 8000v, or is it me?