So I have a simple config of three cisco (IOL) routers setup with IPv6 only. IPv6 routing is enabled globally, IPv6 is enabled on the interfaces and the interfaces have proper IPv6 addresses. Cannot ping directly connected devices, they do not see each other in "show ipv6 neighbor". I have looked all over the place. Anyone else having an issue. Running 6.2.0-6 EVE-NG Pro. Even the Palo Also FW cannot see the routers nor pass v6 traffic to them on the INSIDE.
Thoughts?
IPv6set up but not passing traffic
Moderator: mike
-
rusty725
- Posts: 360
- Joined: Thu Mar 29, 2018 4:19 pm
Re: IPv6set up but not passing traffic
which IOL versions are you using ? also update Eve to the latest version 6.2.0-20
-
Uldis (UD)
- Posts: 5177
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: IPv6set up but not passing traffic
IOL IPv6 works like charm
You do not have the required permissions to view the files attached to this post.
-
Uldis (UD)
- Posts: 5177
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: IPv6set up but not passing traffic
But Palo simply need configure it properly, also works IPv6 without issues
You do not have the required permissions to view the files attached to this post.
-
esparx
- Posts: 2
- Joined: Fri Jan 03, 2025 6:20 pm
Re: IPv6set up but not passing traffic
I am using c1710 12.4-23
c2600 12.4-15.T14
c3640 12.4-25d
c2600 12.4-15.T14
c3640 12.4-25d
-
rusty725
- Posts: 360
- Joined: Thu Mar 29, 2018 4:19 pm
Re: IPv6set up but not passing traffic
you're using very old images called dynamips those are not iol. Get iol instead.